5/16" x 20' Grade 70 Tie Down Chain Assembly - 4,700 lbs. WLL - Made in the USA

SKU:
CA51620G70USA
MPN:
CA51620G70USA
Weight:
24.00 LBS
(0) Write a Review
$69.99
Shipping Timeline Usually Ships 1-2 Business Days
Made in the USA Made in the USA
Not Approved for Overhead Lifting This product is NOT designed or approved for overhead lifting.

Product Description

We are proud to offer domestic grade 70 tie down chain assemblies that are made right here in the U.S.A.! When quality counts, count on American made grade 70 chain to get the job done!
Grade 70 chain is made from high quality, low-alloy carbon steel that is heat treated for additional strength and durability. All of our domestic grade 70 tie down chain assemblies are made in accordance to NACM & ASTM standards, have clevis grab hooks pre-installed on each end, and include embossed grade markings on both the chain and hooks per industry standards.
We also offer domestic grade 70 tie down chain assemblies in bulk drum quantities which are available upon request. Please contact a customer service representative for more information.
These domestic grade 70 tie down chain assemblies are made from “standard-link” type chain. Short link is available upon request.
Please note: Grade 70 tie down chain assemblies are NOT designed or approved for overhead lifting!

Specifications

Stock Status: In Stock
Chain Grade: 70
Chain Size: 5/16"
Chain Finish: Yellow Zinc Chromate
Chain Length: 20'
WLL (Working Load Limit): 4,700 lbs.
MBS (Minimum Breaking Strength): 18,800 lbs.
Weight: 24.00 LBS

Safety Notice

Warning! This product may cause cancer and/or reproductive harm. https://www.p65warnings.ca.gov

Important Safety Information
We work hard to offer the best selection of top-quality safety, rigging, hardware, and cargo control products to our customers. However, when used improperly, serious injury and/or death may occur. The products we sell are intended to be used only by trained professionals in accordance to industry standards, OSHA regulations, as well as State and Federal law.

All products, including/but not limited to cargo control, rigging, and safety equipment should be inspected before each use to ensure they are in proper working order. Any product that is damaged, cut, worn, faded, etc. must NOT be used and must be replaced. Repairing damaged or worn cargo control, rigging, and/or safety products is UNLAWFUL and must NEVER be performed under any circumstance.

Harriscos - Industrial Outfitters assumes no liability resulting from improper selection or misuse of any product we sell.